1 / 1
Ender-3 S1/Ender 3-S1 Pro Adapter for the Universal Enclosure (REQUIRES DRILLING THROUGH PLEXIGLASS) — image 1

Ender-3 S1/Ender 3-S1 Pro Adapter for the Universal Enclosure (REQUIRES DRILLING THROUGH PLEXIGLASS)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Templates and parts for modifying the Universal Enclosure for compatibility with the Ender-3 S1 line of 3D printers

Rating
0 / 5
Likes
9
Downloads
30
Makes
0
Views
663
Reviews
0

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

This is a pretty involved modification, so be warned beforehand! A video tutorial will be released soon - a link will be provided here in the description once its available!

Tools Required:

  • Power Drill
  • 1/4 inch bit
  • 1/8 inch bit (or similar)
  • Eye Protection
  • Masking Tape
  • Scissors
  • Needle Nose Pliers
  • x4 nuts from Universal Enclosure spares
  • x4 bolts from Universal Enclosure spares
  • Allen wrench from Universal Enclosure

 

  • Start by printing off all of the parts & templates
  • Cover the plexiglass for CABLE CUBBY TEMPLATE 1 and POWER CABLE TEMPLATE 1 with masking tape on BOTH sides of the back panel of plexiglass 
    • PLEASE MAKE SURE THAT THIS IS ON THE BOTTOM OF THE BACK PANEL
  • After adding the tape, place the CABLE CUBBY TEMPLATE 1 into position and add a nut and bolt through the existing hole in the plexiglass
  • Using the power drill, create pilot holes using the smaller bit (1/8 inch or similar) in the 2 holes in the center of the rectangular pattern. After the pilot holes, expand the holes using the 1/4inch bit and add a nut and bolt to each
  • Next, add pilot holes to all of the perimeter holes and then expand the hole with the larger bit. 
  • Exchange CABLE CUBBY TEMPLATE 1 with CABLE CUBBY TEMPLATE 2 and ancho into position using the 2 bolts and nuts in the center of the rectanglular pattern
  • Repeat the process of drilling the holes, starting with the holes nearest to the edge of the acrylic
  • Remove CABLE CUBBY TEMPLATE 2 - if the cutout is still attached to the plexiglass, carefully break any remaining acrylic bridges with the needle nose pliers
  • Repeat the process for the POWER CABLE TEMPLATE 1 and POWER CABLE TEMPLATE 2 anchoring in place with the center hole with a bolt and nut
  • Add the CABLE CUBBY MAIN and CABLE CUBBY BACK RIM to the back panel using 4 nuts and 4 bolts
  • Add the back panel plexiglass to the Universal Enclosure and place the Universal Enclosure on a table where you can allow a corner to hang off of the ledge
  • To install the power cable parts, disconnect the power cable from the Ender 
  • Run the power cable through the plexiglass prior to installing the POWER CABLE prints
  • Add the POWER CABLE WASHER to the inside of the enclosure by placing it around the power cable on the inside of the enclosure
  • Place the two POWER CABLE SLEEVE parts around the power cable on the outside of the enclosure 
  • Thread the pieces together with the power cable running between the parts
  • Add the Ender-3 S1 to the enclosure - DONE!

 

Tags