PiZero Vertical Camera Housing rotating & 40x40 drawer compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of 2 designs: 1) PiZero Vertical Screwless Camera Housings by gowen August 08, 2016 2) Ender3 40x40AL…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 142
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a remix of 2 designs:
- PiZero Vertical Screwless Camera Housings
by gowen August 08, 2016
- Ender3 40x40AL Drawer (drawer to fit inside a 40x40 aluminum)
by Edison13 February 10, 2019 // for some reason I cannot attribute both designs.
40x40AL_drawer_v3.STL was edited into the small_mod_40x40_drawer.stl for testing.
M4 screw and nut used for GoPro base
M2 screw and nut were used to connect the base to the GoPro base to the cam base
The small hole is 2mm in the design so itjust barely allows a 1.75 peice of filament to be used if you don't have an M2 screw.
To DO:
a) The Cam base needs to be edited to allow for a embedded nut. Currently the little M2 nut partially blocks the SD card so the fit is not perfect.
b) The Clamp file will not fit until the Embedded nut "fix" is done
c) Need to modify the "front" of the 40x40 drawer. It shows a gap since I created the "slot" for the GoPro base.
Print Settings
Printer:
Elegoo Neptune 2
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
20
Filament:
Duramic PETGRed
Notes:
The Elegoo Neptune 2 is an Ender 3 v2 clone (I think) I am using the 40x40 extrusions on the printer's base to insert the drawer and hold the PiZero case.
Category: 3D Printer Accessories