Rode style mic boom desk clamp base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is to replace a broken base mount clamp for a microphone boom arm. Not an exact Rode replacement, but very similar.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 119
- Wydruki
- 0
- Wyświetlenia
- 1494
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Public Domain
This desk mount clamp base for a mic boom arm that was copied and sold under many various vendor names. These original mounts tend to break where the clamp arm inserts to the base mount. This won't fit the Rode arm, but is very similar and with a little editing of the Step file should get you very close.
I printed with PLA at 50% infill, but it can probably go to 20-35%. Printed without support, but will need a little clean-up inside where desk clamp inserts to base mount.
A step file was exported from Fusion360 in case dimensions need to be changed for boom arm hole, etc.