1 / 5
Z-nut adapter for mendel90, to use lead screws — zdjęcie 1
1 / 5

Z-nut adapter for mendel90, to use lead screws

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

To fit lead screw nuts to Mendel90 Z-axis. See photo's. Parametric .scad file, can be adjusted for other sizes.

Ocena
0 / 5
Polubienia
1
Pobrania
22
Wydruki
0
Wyświetlenia
152
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

To fit lead screw nuts to Mendel90 Z-axis. See photo's.

Parametric .scad file, can be adjusted for other sizes.

Print Settings

Printer:

Mendel90

Rafts: 

No

Supports:

No

Resolution: 

0.3

Infill:

20%

Filament:

PETG green (does not matter)


 

Notes:

 

I printed these with a 0.6 mm nozzle, 0.3mm layer height, in green PETG. But smaller nozzle should also work, just make sure it prints sturdy enough to fit the screws. I used 2.5mmx12mm parkers, smaller might also work. The .scad file is parametric and can be adapted to other hardware.

edit: They are held in place by gravity & a bit of friction, no glue needed. In case of ‘oops, sent nozzle below bed’ they can be pulled out by the motors and save the bed. But no guarantees on that.

Tagi