DnD 3 digit HP counter combined number dial with flush numbers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
wanted the numbers to look a bit cleaner on the dials and combined the dial backs as well.
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 1712
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Board Games
- Licencja
- Creative Commons — Attribution — Share Alike
I liked these hp counters but the numbers looked a little rough so used a similar technique i used on my flash tiles, example photos were printed at 80% and I skipped the 3rd filament change to save on the gold filament but I would recommend doing the 3rd change to avoid gap issue. Also 100% size will likely give better finish I just like the smaller size.
Example photos were printed on mk3s+ without a mmu. Just a little patience doing manual filament changes.
The file provided has separate parts for each number if you're used to multi material printing with a mmu do the usual.
This file just replaces the num_bot and num_top from the original.
Slicer settings
for printers without a mmu or equivalent
0.2 layer height
set number of extruders to 2
add the g code m600 to the custom g code section for tool changes
add a wipe tower in a free corner for best results
if using wipe tower enable “No sparse layers” to avoid filament waste