Ikea Couch Finnala Leg Extension
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Raises the Finnala couch (and maybe a few other models) up 38mm (1.5 inches)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 535
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
Found that we can't vacuum under our Ikea Finnala Couch. Decided to print an easy extender to the chair legs. Holding up well so far, for our 6 seat corner sectional with ottomans.
Print with enough bottom/top layers so there is no infill between the inner cavity and the bottom of the model - this will ensure the strength. (which is also the reason for the 6 “spokes” inside. 4 Perimeters as well.
This “cup” raises the couch 38mm or 1.5 inches. Just enough for our roomba clone “levant” vaccum to sneak under.
I’ve put them on my ottoman and loaded it down with 350lbs of people bouncing around and it held solid! I did not remove the default ikea felt pads from the bottom of the existing legs, and will need to add new felt pads to the bottom again to protect my floors, but as a first test I am happy. however - use at your own risk, if you’ve got 1000lbs of people moving on a couch your results may vary. (But I’ll be doing this - we have a huge sectional)
updated photos!