1 / 1
PTFE Quick-Connector to Drybox - Bayonet-Lock - Receiver w/ Flathead
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of the excellent bayonet-lock quick-connect that uses flat-head M3 screws instead.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 36
- Wydruki
- 0
- Wyświetlenia
- 351
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Changelog:
V2
Updated to V2 from parent model.
V2.1
- Fixed an issue where the filament scrapes against the brass of the base of the PC4-M6 fittings I have. I added a collar around the hole. When the fittings screw in now, they butt up against the collar.
- Fixed an issue where the pegs on the printed peg versions of the fittings are just a tad too tall, making it difficult to screw in my fittings. I reduced them by about 3mm.
- I wanted a tighter friction fit between the plugs and the receivers. I offset the faces of the bayonet legs by 0.2mm to make them a little more snug.
- Added PC4-M10 pass-through fittings. I modified the design to allow PC4-M10's as well.
- For the standard plug, I added a 3mm to 1mm cone. The idea is that you can ram your filament into it before you mate the plug to the base. That way, filament doesn't bounce around inside the dry box if you aren't using it. Also, you don't have to go fish the filament out.