Cyclone Dust Collector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My own take on a 5 Gallon (19 Liter) bucket Cyclone Dust Collector - designed to accept 51mm O.D. central vacuum piping.
- Ocena
- 0 / 5
- Polubienia
- 63
- Pobrania
- 260
- Wydruki
- 1
- Wyświetlenia
- 3520
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
Not content with the designs already out there, I designed my own cyclone dust collector to achieve the following:
- print quick and cheap (<400g of filament!)
- use minimal supports (see ‘Support Deck’ section below)
- integrate a vacuum relief valve (see ‘Vacuum Relief Valve’ section below)
- Accept the 51mm O.D. pipes that my central vacuum uses
Support Deck
In order to reduce the amount of supports that needed printing, I incorporated a sacrificial ‘Support Deck’ within the intake port. This is removed post-print along with the supports that are on it. There's a similar support deck in the vacuum relief elbow.
Vacuum Relief Valve
I integrated the Vacuum Relief Valve into a 90 degree elbow that mates to the output port. You'll need the following hardware to complete the valve:
- M3x30 bolt
- M3 nylon lock nut
- Two M3 washers
- The spring from a BIC® Clic Stic® Pen
Here's a video of the relief valve in action!
Connecting The Parts
I first used a lot of superglue to connect the ‘top’ and ‘cone’ pieces together - then I went over the seam with a 3D pen to complete the seal. I then repeated the process when attaching the whole assembly to a pre-cut hole in the 5 gallon bucket lid.