Ebike controller mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Seat-post mount for an ebike controller box
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 75
- Wydruki
- 0
- Wyświetlenia
- 1015
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is a bracket for mounting an ebike controller box to the seat tube. My particular seat tube is 32mm in diameter. The controller was part of a Leeds ebike conversion kit. There are no pre-drilled holes for mounting the actual box, these can be drilled afterwards to suit your individual needs. Small zip ties thread through the mount and around the seat tube; I had to daisy-chain two each to wrap around the seat tube.
You'll want to print with supports. Infill shouldn't matter much (only on the section near the seat tube) but I went with 60% gyroid. I used ABS but PETG should work equally fine.