Ebike controller mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Seat-post mount for an ebike controller box
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 75
- Makes
- 0
- Views
- 1,015
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This design is a bracket for mounting an ebike controller box to the seat tube. My particular seat tube is 32mm in diameter. The controller was part of a Leeds ebike conversion kit. There are no pre-drilled holes for mounting the actual box, these can be drilled afterwards to suit your individual needs. Small zip ties thread through the mount and around the seat tube; I had to daisy-chain two each to wrap around the seat tube.
You'll want to print with supports. Infill shouldn't matter much (only on the section near the seat tube) but I went with 60% gyroid. I used ABS but PETG should work equally fine.