1 / 5
ZK-4KX (XK-4KX) Buck Boost Converter case / enclosure — zdjęcie 1
1 / 5

ZK-4KX (XK-4KX) Buck Boost Converter case / enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Easy to print (no supports) and easy to use (no need to remove the device out to connect or disconnect the wires!

Ocena
5 / 5
Polubienia
18
Pobrania
218
Wydruki
1
Wyświetlenia
1138
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

Simple enclosure for ZK-4KX or XK-4KX buck/boost DC-DC converter. A lot of big vent holes from all sides for better cooling. Wires can be mounted and dismounted without removing the device out of the case. An additional external fan is recommended when used with high current.

My print settings: PETG, 0.4 nozzle, 0.2 layer height, 2 walls, 4 top, 4 bottom, 24.9% grid infill (only used for left and right walls because they are thick and we don't need tons of plastic there), 25mm/s walls speed, no supports. I recommend to test and find the best retract settings for your printer using some test models before printing this enclosure because there will be a lot of retracts there! Fast printing speed and non-optimized retract settings result in ugly vent holes!

How to use: just insert the device inside, it holds very strong and it will never fall out of there! If you need to get it out, separate the top side of the device and the case with your nail to make a gap between them all the sides around, then it can be opened easier with hands.

License: free for personal non-commercial use, not for sale!

Tagi