Prusa MK3/MK4 Enclosure Built with an IKEA LACK Table
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This enclosure is meant to be placed on top of an existing table.
- Ocena
- 0 / 5
- Polubienia
- 45
- Pobrania
- 106
- Wydruki
- 0
- Wyświetlenia
- 3336
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This enclosure is meant to be placed on top of an existing table. I built it this way because I feed my printers from spools placed on roller bearings going through rods hanging from the ceiling of my utility room. I do not need to place the spools on top of the enclosure. I can see and service the printers more easily than with the other LACK-derived enclosures.
The table requires plexiglass.
3 sheets cut to 440mm x 440mm
2 sheets cut to 220mm x 440mm
The plexiglass can be purchased, in pre-cut form, at
I made a long YouTube video to explain how I assembled it.
This video shows my third table being built. The design has gone through several iterations and I think it now works fine. Most kinks have been removed.
Note: you will need
- 8 drywall screws (35 mm or so)
- 20 small wood screws (25 mm or so)
- M3 bolts
- Epoxy glue
- Plexiglass
- Two small neodymium magnets
DO NOT FORGET TO PAUSE THE PRINT TO ADD THE TWO MAGNETS