Prusa MK3/MK4 Enclosure Built with an IKEA LACK Table
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This enclosure is meant to be placed on top of an existing table.
- Rating
- 0 / 5
- Likes
- 45
- Downloads
- 107
- Makes
- 0
- Views
- 3,353
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This enclosure is meant to be placed on top of an existing table. I built it this way because I feed my printers from spools placed on roller bearings going through rods hanging from the ceiling of my utility room. I do not need to place the spools on top of the enclosure. I can see and service the printers more easily than with the other LACK-derived enclosures.
The table requires plexiglass.
3 sheets cut to 440mm x 440mm
2 sheets cut to 220mm x 440mm
The plexiglass can be purchased, in pre-cut form, at
I made a long YouTube video to explain how I assembled it.
This video shows my third table being built. The design has gone through several iterations and I think it now works fine. Most kinks have been removed.
Note: you will need
- 8 drywall screws (35 mm or so)
- 20 small wood screws (25 mm or so)
- M3 bolts
- Epoxy glue
- Plexiglass
- Two small neodymium magnets
DO NOT FORGET TO PAUSE THE PRINT TO ADD THE TWO MAGNETS