1 / 4
Air-O-Swiss/Boneco Venturi style mist booster (High static pressure fan required) — zdjęcie 1
1 / 4

Air-O-Swiss/Boneco Venturi style mist booster (High static pressure fan required)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fixes the issue with the u700 not being able to push the mist far enough. Pictures are of the first design which was bad

Ocena
5 / 5
Polubienia
11
Pobrania
65
Wydruki
1
Wyświetlenia
1452
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Living Room
Licencja
Creative Commons — Attribution

This model uses a Enterprise grade Delta BFB1012HH 33mx58mm but i would recommend finding a slower spinning model because even running at 6 volts (half the voltage) its not quiet.

This fixes the issue with this humidifier and its highest setting not pushing the air hard enough and making a massive mess if you actually want to use this printer at its full ability.

I had to run another humidifier because it wasnt able to dissapate the mist at 100% but now its absolutely perfect.

Print with 5-10 percent supports

UPDATE New 40mm model fixed a lot of issues. Its not a ground up redesign but it should preform much better. I'm using a 40x20 because the higher flow and pressure still required. I eventually plan on trying a Noctua 40x20 but I'm not sure it will work.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

No

Supports:

Yes

Resolution:

0.16

Infill:

25%


Filament:

Inland trash filiment PETG poop

Notes:

Definitely use PETG and not pla for many reasons. It will print just fine but pla isnt as robust and PEGT tends to hold up better under harsher conditions.

Cover it in a rubberized coating if you plan to use it because the surface finish will get moldy otherwise

Category: Household

Tagi