Housing for DIY vactrol
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Currently I'm trying to build a DIY Synth and some modules require for the control voltage a vactrol which is simply a…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 111
- Wydruki
- 1
- Wyświetlenia
- 1007
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Currently I'm trying to build a DIY Synth and some modules require for the control voltage a vactrol which is simply a LED and a LDR (Light Dependent Resistor).
Most of the time you see people using a shrinking tube oder just tape to get these two together but I thought I wanna print something. So here it is. A 3D printed housing.
The LDR goes into the tube and the LED into the outer part. After that you can slide the tube into the housing.
With PLA it's a little bit lose but it makes space for a drop of super glue. With PETG it just fits perfectly.