Collapsable Draw Bridge Doorstop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
Printing
Layer Height 0.20mm or lower
No supports needed
Material: TPU and PLA (I used a mat PLA but most types should work)
Perimeters: The TPU part 4 or more others can be juist 2
Assembly/Installation
begin by pushing in the TPU part into the bridge but don't push on the hinges it can be a bit tight if you had some stringing make sure it is all removed otherwise it will not fit
Can be screwed in place with 4 3.5mm countersunk screws or adhered with double sided tape on the "gate" pieces after adding the bridge
If your going to screw it in place. Pinch at the top when screwing in the second screw. Because there are dimples on either sides to hold the bridge up. now you can screw in the bottom two
combine the two gate pieces and push it on the bridge while the bridge is horizontal.
If your going to adhere it to a door, you can juist assemble it beforehand and add tape afterwards
Installation
the bridge should be nearly or completely down with the TPU part digging into the floor
Bonus
on top there is a slot for 1x8 brick plate