Collapsable Draw Bridge Doorstop
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.91 – €2.34 net (excluding VAT)
For file: DrawBridge_0.2mm_PLA_MK3S_2h24m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €2.12 excluding VAT (range midpoint).
- Weight reported by the author
- 21 g
- Print time reported by the author
- 2.39 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
If your house is your castle than where is the draw bridge? Wel now its holding your door!
- Rating
- 0 / 5
- Likes
- 41
- Downloads
- 82
- Makes
- 0
- Views
- 1,071
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Share Alike
Printing
Layer Height 0.20mm or lower
No supports needed
Material: TPU and PLA (I used a mat PLA but most types should work)
Perimeters: The TPU part 4 or more others can be juist 2
Assembly/Installation
begin by pushing in the TPU part into the bridge but don't push on the hinges it can be a bit tight if you had some stringing make sure it is all removed otherwise it will not fit
Can be screwed in place with 4 3.5mm countersunk screws or adhered with double sided tape on the "gate" pieces after adding the bridge
If your going to screw it in place. Pinch at the top when screwing in the second screw. Because there are dimples on either sides to hold the bridge up. now you can screw in the bottom two
combine the two gate pieces and push it on the bridge while the bridge is horizontal.
If your going to adhere it to a door, you can juist assemble it beforehand and add tape afterwards
Installation
the bridge should be nearly or completely down with the TPU part digging into the floor
Bonus
on top there is a slot for 1x8 brick plate