1 / 4
LR44 Battery Dispenser for IKEA Skadis
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A double magazine of LR44 batteries with dispenser mechanic for the IKEA Skadis board.
- Ocena
- 4,5 / 5
- Polubienia
- 37
- Pobrania
- 139
- Wydruki
- 6
- Wyświetlenia
- 998
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (5)Wydruki i komentarze (Wydruki: 6) (Komentarze: 7)Remiksy (1)Kolekcje (67)Powiązane
Hi folks, I created this dispenser as I did not find any suitable LR44 dispenser that as well fits to the SKADIS board. After some iterations it works fine now. The fiddly part is to fill it up with batteries. I'm open on some ideas to solve this as well. Based on feedback and acceptance I will spend further time on this.
Print instructions:
- There are no specific print instructions, unfortunately a minimum support for the Skadis hooks is required.
- Other proposed supports could be removed without any disadvantage.
- I added the project file for MK4 with PLA, however it may work as well with PETG.
- To make it look nice I selected 0.1mm FAST DETAIL profile ad did not test other layer heights. There you may find some in the comments or makes section.
Assembly:
- Please pay attention to the wheel assembly. One side has a chamfer in the inner hole which needs to be downside on the base.
- The remaining assembly is just snap in top and base. Apply optional glue to close it forever.
Happy printing!