Onewheel V1 front concave footpad
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This foot pad is mounted over the original front footpad and has a 5mm side to side concave, and about an 11mm lift at…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
This foot pad is mounted over the original front footpad and has a 5mm side to side concave, and about an 11mm lift at the front lip. I printed it standing on the front facing edge with a 10mm brim. It leaves a 2 mm gap between it and the sensors as not to give false sensor readings, but if you leave about a 15mm overhang of grip tape, it will seal against the original pad so no gravel gets under. I mounted it with double sided tape, but it would work just fine being glued. If you experience any issues please tell.
Category: Hobby