1 / 2
Freely Adjustable Spool Holder (Remix of Prusa MINI+ Spool Holder)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The remix of the "Prusa MINI+ Spool Holder" with freely adjustable spool base "on the fly", without using any tools.
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 148
- Wydruki
- 5
- Wyświetlenia
- 791
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (7)Wydruki i komentarze (Wydruki: 5) (Komentarze: 8)Remiksy (2)Kolekcje (43)Powiązane
Not only for MINI and not only for 2kg spools - it works with the small 500g spool and any with a diameter larger than 15cm!
Required Materials
You will need the following materials:
- Printed Base parts (4x)
- Printed Rail parts (2x)
- Printed Adjustment Rods (2x) - help you to adjust the proper distance of the rails, as the cutouts on the base parts have ±0.20mm tolerances
- Printed Rim parts (4x) - optional for 608 bearings to prevent spools grinding against the sides
- Bearing 608, 608Z or 608ZZ (4x) - 22mm outer diameter, 8mm inner diameter, 7mm wide (optionally you can use these 3D printed-in-place 608 bearings, even though I recommend getting real ones)
- M3x12 screws (4x) - for connecting the two sides of the base
- M3n nuts (4x) - for connecting the two sides of the base
- M3x8 screws (2x) - for connecting the leftmost base to the rails and holding it in place
- 10-12mm wide two-sided adhesive tape - optional to fix the rails to the enclosure (you don't need to use it along the entire length of the rails, just enough to hold it in place)