Bambulab Poop Chute

I currently advise against using the model, as there is a possibility, albeit minimal, for small amounts of filament residue to fall through the small bamboo window openings.

 When I have the time, there will be a new version released.

I designed it in the hope that I thought maybe I could make my already relatively quiet p1p (thanks to the enclosure) even quieter and also make it more challenging for dust.

As for the quieter noises, I personally can't really perceive them. 

Depending on how well your printer is calibrated, you may need to use super glue for the 6x3mm magnets; I needed a total of 6 of them to ensure it doesn't move even with a lot of vibration. 

A few more tips: 

-Additionally, on the p1p, there's a screw above the poop outlet; you can use this as a reference point. Once the screw is just barely covered from the top edge, the thing is perfectly positioned in the right spot.

-If you want to achieve a better print quality than I did, try using more support for your model.

-I printed it upright at a 90-degree angle, but there might be an even more optimal position. However, it worked quite well with tree supports.

Like this model? Want to support me?
Buy me a coffee <3

buymeacoffee.com/pyz3d