1 / 2
Pulley sleeve for "Perfect Gear Bearing v2" — zdjęcie 1
1 / 2

Pulley sleeve for "Perfect Gear Bearing v2"

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A push fit sleeve that fits onto this 3d printed bearing, that turns it into a pulley.

Ocena
5 / 5
Polubienia
14
Pobrania
112
Wydruki
2
Wyświetlenia
732
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I needed a pulley for my automatic chicken coup door. Started to design one around some 608 bearings I had lying around, but realized that the outside was probably going to rust.

So I made one around a fully 3d-printable bearing that I found worked well. Its just a ring that you can press around this bearing and hey presto, a simple pulley.

Can't say how long it will hold up to various loads. But seems to work fine for my very simple use-case.

For me the press-fit worked well, but might need a drop of glue if its too loose.

I did not design the bearing itself, the model is by user Gamma4D.

Printed in PLA with 0.2mm layers and no supports.

Tagi