Voron 0.2 Kirigami EBB36 mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two small brackets to mount a Bigtreetech EBB36 CAN bus module to the Voron 0.2 Kirigami sheet metal bed frame.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 1058
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Bigtreetech EBB36 can bus board is normally intended to be used on the extruder.
However it also fits pretty nicely into the cutout of the Kirigami sheet metal bed mount.
This are two small support brackets that attach to two of the pre-existing through holes of the Kirigami bed. They are designed for 4.1mm heat set inserts.
I use it to control the bed heater, front RGB LED, nozzle auto-Z touch point and chamber fan (not pictured on the image) all while running only 4 wires through the bed drag chain.
Installation
I won't lie - it's pretty fiddly to mount the board and install the bed without excessive cable lengths but it is doable. I recommend to place the printer on it's side for easier access.