1 / 3
Z wobble compliant mechanism for SFU1204 ball screw — zdjęcie 1
1 / 3

Z wobble compliant mechanism for SFU1204 ball screw

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Little spacer for 12mm balls crew to reduce/eliminate Z banding using compliant mechanism

Ocena
0 / 5
Polubienia
64
Pobrania
221
Wydruki
0
Wyświetlenia
2127
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution



* STILL IN BETA *
This is an anti-wobble system do reduce or eliminate z wobble or z banding using a compliant mechanism at its center. This mechanism has been tried in two version. One with machined part with an insert at the middle and an other version fully printed. Because of the intricate geometries the recommended printing method in SLS. It has been tested in PA12 with good result at 0.3mm ‘’fins'' inside the mechanism.

Unlike Oldham coupling it doesn't have any moving part so no backlash.

Unlike Wobble X you don't need to redesign anything for it because it's only a spacer. On top of that this mechanism supports forces in both Z directions ( without coming apart or relied on gravity to do his job )

The installation is a bit tricky to do because you need to screw down each screws a bit a time so everything can go down all together 

https://grabcad.com/library/z-wobble-compliant-mechanism-for-sfu1204-ball-screw-1

Tagi