Alternate Poorest Man Feeder design, no supports remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of DNA-topoisomerase's excellent compact remix of the PMF
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 390
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
I loved dna-topoisomerase's remix of the PMF, but hate supports. Accordingly, I remixed the model to be printable without supports enabled. (The only required support is a built-in support for the peeler lever.) I also made a couple mechanical changes in the interest of longevity / ease of use.
This required splitting the main body into a couple additional pieces, which are held together by indexing pins and M3 flat head cap screws. The above cutaway views should hopefully show how these are meant to fit together.
Additionally, I made the following modifications:
- large peeler gear and lever arm now pivot on M3 dowel pins (12mm and 16mm, respectively) instead of screws
- the tensioner screw now engages with a brass M3x4x5mm heatset insert rather than plastic
- the spool holder knob can be changed and attaches with an M3 screw and heatset insert
- the side cover attaches using M3 FHCS
In total, the additional hardware required for this remix is as follows:
- 1x M3x12mm dowel pin
- 1x M3x16mm dowel pin
- 2x M3x8mm FHCS
- 1x M3x10mm FHCS
- 2x M3x12mm FHCS
- 3x M3x16mm FHCS
- 1x M3x30mm SHCS