1 / 5
Gehäuse für Mini-STX - Asus H110S1 und H110S1/CSM — zdjęcie 1
1 / 5

Gehäuse für Mini-STX - Asus H110S1 und H110S1/CSM

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Asus Mini-STX H110S1 und H110S1/CSM Mini-STX Form Factor: 5.5 in. x 5.8 in. 14.0 cm x 14.7 cm

Ocena
0 / 5
Polubienia
7
Pobrania
73
Wydruki
0
Wyświetlenia
440
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Deutsch:

Da ich nirgendwo ein Mini-STX Gehäuse gefunden habe, musste ich es selber erstellen.

Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm

Der originale Intel Lüfter war mir zu hoch, deshalb trennte ich den Lüfter ab und befestigte einen kleineren Lüfter mit Klettband. Betreibe den PC mit einem Celeron. 

H110 S1 Fuß Final 4 mal drucken, seitliches Gitter Final 2 mal drucken, der Rest 1 mal drucken.

Zusätzlich erforderlich 4 Schrauben  M4 x 25 mm, nicht zu feste anziehen je nach Filament.

1 Taster mit 12 mm Durchmesser

Änderung H110 S1 oben Final  zu  H110 S1 oben Final v9

english:

Since I couldn't find a Mini-STX case anywhere, I had to build it myself. 

Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm 

The original Intel fan was too high for me, so I disconnected the fan and attached a smaller fan with Velcro. Run your PC with a Celeron.

H110 S1 Foot Final 4 times, Side Grid Final 2 times, rest print 1 time. In addition, required 4 screws M4 x 25 mm, not too tight depending on the filament.

1 switch with a diameter of 12 mm

Change H110 S1 top Final to H110 S1 top Final v9