Gehäuse für Mini-STX - Asus H110S1 und H110S1/CSM
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Asus Mini-STX H110S1 und H110S1/CSM Mini-STX Form Factor: 5.5 in. x 5.8 in. 14.0 cm x 14.7 cm
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 73
- Makes
- 0
- Views
- 440
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Deutsch:
Da ich nirgendwo ein Mini-STX Gehäuse gefunden habe, musste ich es selber erstellen.
Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm
Der originale Intel Lüfter war mir zu hoch, deshalb trennte ich den Lüfter ab und befestigte einen kleineren Lüfter mit Klettband. Betreibe den PC mit einem Celeron.
H110 S1 Fuß Final 4 mal drucken, seitliches Gitter Final 2 mal drucken, der Rest 1 mal drucken.
Zusätzlich erforderlich 4 Schrauben M4 x 25 mm, nicht zu feste anziehen je nach Filament.
1 Taster mit 12 mm Durchmesser
Änderung H110 S1 oben Final zu H110 S1 oben Final v9
english:
Since I couldn't find a Mini-STX case anywhere, I had to build it myself.
Mini-STX Form Factor: 5.5 in. x 5.8 in. / 14.0 cm x 14.7 cm
The original Intel fan was too high for me, so I disconnected the fan and attached a smaller fan with Velcro. Run your PC with a Celeron.
H110 S1 Foot Final 4 times, Side Grid Final 2 times, rest print 1 time. In addition, required 4 screws M4 x 25 mm, not too tight depending on the filament.
1 switch with a diameter of 12 mm