Ultimaker S3, S5, S7 NFC connector & Spool holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A spool holder for Ultimaker machines to hold the larger 1 kg spools that's still compatible with the NFC reader.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 470
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print the pin on the large flat head. Print the guide on the flat side. Neither will need support.
Print the spool holder on the side with support “touching buildplate only" and then add custom supports on the areas that still overhang at too great of an angle. Alternatively, you can use the “support everywhere” but use support blockers on the area that holds the NFC card. The card should friction fit in on its own, but a dab of hot glue after assembly won't hurt if you need it.
The cord for the NFC goes through the hole on the back. Two routing options are given, on the side, or through the bottom.
Print with 15-25% infill and 1.2-2.0mm walls. Using a 0.4mm head, a layer height of 0.16-0.22mm. Smaller is better.