1 / 2
No-Mess Dosing and WDT Funnel for 58mm Baskets (magnetic) — zdjęcie 1
1 / 2

No-Mess Dosing and WDT Funnel for 58mm Baskets (magnetic)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tamp-through magnetic funnel that stops grounds from getting stuck between the basket and the funnel during WDT.

Ocena
0 / 5
Polubienia
3
Pobrania
39
Wydruki
0
Wyświetlenia
508
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Share Alike

A funnel with a small lip that wraps around the edge of 58mm baskets to help prevent grounds from getting trapped between the funnel and the basket during aggressive WDT, and eventually ending up on your counter. The lip is small enough that the basket can be tamped with the funnel on.

The cutouts are designed to fit the lugs of a Gaggia Classic portafilter, but will probably fit most 58mm portafilters.

This remix adds slots for 24 magnets to be inserted after printing. The magnets are 4mm diameter x 1.75 high. I used magnets from this assorted set on Amazon. With my printer the fit was tight enough that I didn't need glue, but your mileage may vary.

The funnel has been tested and works well with IMS and VST 58mm baskets, but it may be compatible with others.

Food Safety

Printing a part from food safe plastic does not make it food safe! The surface of FDM 3D prints traps bacteria and is usually not water-tight, even if it looks like it is.

Because the funnel is in regular contact with coffee, it should be coated with an epoxy specifically approved for food contact. The funnel in the pictures is coated with MAX CLR which is formulated for direct food contact in accordance with FDA regulations. Always follow all manufacturer curing and use guidelines to ensure the finish is food safe. Be sure to wash the part with warm soapy water after the epoxy cures before using.

Printing Recommendations

I was able to print this in PETG on a Prusa  powder coated satin PEI sheet with the top of the funnel facing down without a brim or supports. A brim may be necessary if you have adhesion issues.

If you find your magnets aren't fitting, try setting the "external perimeters first" setting in your slicer.

I also recommend using variable layer height and reducing layer height around the basket lip so it matches the designed profile as closely as possible, though I have had success printing at 0.2mm layer height as well. Epoxy will help smooth things out either way. 

Tagi