K1 Side Spool Holder Ball Bearing or Factory
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Like many others, tired of the rear mounted spool holder. Here is my version of the side mount
- Ocena
- 5 / 5
- Polubienia
- 29
- Pobrania
- 182
- Wydruki
- 2
- Wyświetlenia
- 1357
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted a side mount spool holder and this is what i came up with.
I wanted it to look like it “belongs” on the K1, so i tried to copy the style of the frame as much as i could.
The tension on the spool is adjustable so you can tune it for different filaments / print speeds / etc. If you print the knob then you wont even need tools to adjust it.
You will need 1 each of the printed parts and -
(4) M3 x 12 screws
(4) M8 Flat Washers
(2) 22x8x7 roller bearings.
(1) M8 x 100 Hex Head bolt
(1) M8 Nylock Nut
Print the Spool Screw and Spool Nut with the widest ends down (threads pointing up), supports only touching build plate - Do not support the threads.
If printing with 0.4 nozzle - print at .16 or lower layer height
If printing with 0.6 Nozzle - print at .18 or lower layer height
Printing without support at these layer heights and you will not have to clean up the threads.
The knob and frame can be printed however you like.
The knob is just a press fit over your nylock nut.
In the exploded view you can see that i added some screws and inserts around the spool base for layer adhesion support. As it turns out those are not even remotely necessary and have been removed from the model. Please ignore.
- Update 03112024 - Added a spool holder frame for the factory stand off
Enjoy!!