BIQU H2 mount for Mercury One.1 EVA 2.4
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a mount for the BIQU H2 extruders for the Ender 5 CoreXY modification Mercury 1.1 with the EVA 2.4 toolhead
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 145
- Wydruki
- 0
- Wyświetlenia
- 892
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a single piece BIQU H2 extruder mount to fit the EVA 2.4 system for the updated Mercury 1.1.
The mount has been designed to keep the extruder firmly in place and prevent rotation when moving fast in the X and Y axis.
There is a cutout to route the hot end and thermistor wires on the right side to fit between the mount and the Trihorn cooling duct (2021 model only) and can be secured with the cable tie holes on the bottom piece.
All the screws should be available as spares from the BoM list.
The mounting plate uses three M3x8mm SHCS screws and the 2021 extruder is held in place with four M3x8mm SHCS screws. Only two are required and all the newer versions only use two screws.
The Trihorn extension for the 2021, V2S and Revo models are 13.8mm long and requires two M3x30mm screws to attach the cooling duct. 25mm screws might reach but this is untested.
The Trihorn extension for the V2.0 model is 11.35mm long and requires two M3x25mm screws. Note: I am not 100% sure if the V2.0 requires this or the longer extension due to the BIQU drawings being messed up for this one.
Based on your heater block rotation, the narrow Trihorn cooling duct will touch the silicone sock. The wide version is shown in the photos.
You can find the wide and narrow Trihorn cooling ducts here:
https://github.com/ZeroGDesign/docs/tree/gh-pages/docs/assets/stl/eva2_4
NOTE! Due to the toolhead being updated, I have attached the original TriHorn files and bottom piece required for this mount.
STEP files now included if you wish to make your own remix!