1 / 2
Expandable Steel Sheet Holder for Prusa Enclosure — zdjęcie 1
1 / 2

Expandable Steel Sheet Holder for Prusa Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified version of Whity's expandable steel sheet holder for mounting on the side of the Original Prusa Enclosure.

Ocena
4,895 / 5
Polubienia
73
Pobrania
280
Wydruki
20
Wyświetlenia
1794
Oceny
19

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Remix for installing Whity's Steel Sheet Holders on the side of the Original Prusa Enclosure. Only for MK sheets.

You only need to print one of each part. If you need more holders, rest can be original unmodified versions.

Print instructions

Print settings are same as in original model.

Original instructions when I made this remix:

Print with 0.2mm layer height. No supports needed.

  1. Rotate the side parts 50° to fit on the print bed.
  2. Adjust the "Fill Angle" by 50° too

Assembly Instructions

Remove 4 x nylon rivets holding the clear panel to the frame.

From inside, insert M3x6 and M3x12 screws and fasten them to M3 nuts in printed parts (see photo).

 

Update 10.2.2024

New version for mounting on the bottom of the enclosure. Sheets are accessed from the side of the enclosure. Mounting with 4 x M3x6 and 4 x M3 nuts.

Tagi