Tenlog TL3D Pro power supply "housing"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduce thermal stress on electrolytic capacitors in the power supply (after replacing them).
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 116
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Needs some 3x8mm and 4x8mm screws - watch out that those attached to the powersupply do not reach to far into the powersupply - otherwise one risks a shorted circuit which might even end deadly.
For connecting to the mains I reused the original switch and plug.
For connecting the printer I used https://www.printables.com/model/91517-wago-221-2411-plate-mount/comments/1237940
I printed in PLA with 0.3mm layer height and 20% infill.
Room for improvement:
The WAGO clips could have more distance
The switch could sit tighter
The internal cabling should have black/red for -/+ (instead of blue only)
The front plate has +/- embedded (by moving it one layer up) - should have printed that in dual color mode