Tenlog TL3D Pro power supply "housing"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Reduce thermal stress on electrolytic capacitors in the power supply (after replacing them).
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 12
- Makes
- 0
- Views
- 115
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
Needs some 3x8mm and 4x8mm screws - watch out that those attached to the powersupply do not reach to far into the powersupply - otherwise one risks a shorted circuit which might even end deadly.
For connecting to the mains I reused the original switch and plug.
For connecting the printer I used https://www.printables.com/model/91517-wago-221-2411-plate-mount/comments/1237940
I printed in PLA with 0.3mm layer height and 20% infill.
Room for improvement:
The WAGO clips could have more distance
The switch could sit tighter
The internal cabling should have black/red for -/+ (instead of blue only)
The front plate has +/- embedded (by moving it one layer up) - should have printed that in dual color mode