LayersFactory
Zgłoś model
1 / 12
FLSUN QQ-S Pro Part Cooler Duct — zdjęcie 1
1 / 12

FLSUN QQ-S Pro Part Cooler Duct

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Markus

Markus

@Markus_133597

Update: 2021-02-19 Found an error on the E3D Version, when reprinting the duct for myself deleted the faulty version…

Ocena
5 / 5
Polubienia
13
Pobrania
137
Wydruki
1
Wyświetlenia
472
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Printer Parts & Upgrades
Licencja
Creative Commons — Attribution
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 1) (Komentarze: 1)Remiksy (0)Kolekcje (10)Powiązane

Update: 2021-02-19

  • Found an error on the E3D Version, when reprinting the duct for myself
  • deleted the faulty version and uploaded the corrected one

Update: 2021-01-16

  • Finished the Support Free Version
  • Made a Version for an E3Dv6 Hotend
  • Made CFD Simulations for all Versions
  • Renamed the STL's

Update: 2020-12-21

Redesign of Variant 1 (FLSun QQ-S Pro Duct v4):

  • Better Fit and Snap
  • 1mm "Ring" to better cover the printers opening
  • Nozzle better centered
  • Airflow optimized

Most of the existing designs were not quite OK for my Stock QQ-S Pro.

Almost all (I tried) where blowing directly onto the nozzle.

Compared to the stock duct you might need to decrease your fan-speed.

PID Tuning after replacement is recommended.

I recommend using PETG or ABS for printing. After serval testprints I finally used GreenTEC Pro from extrudr (it prints almost like PLA using temps like PETG, but it is Heat resistance up to 160°C VICAT A / 115°C HDT/B*)

Print Settings

Printer:

FLSUN QQ-S Pro

Rafts:

No

Supports:

Yes

Resolution:

0.16, 0.20

Infill:

doesn't matter

Filament:

extrudr GreenTEC Pro

doesn't matter


Notes:

For the first prints on my FLSUN QQ-S Pro I was additionally using a raft as the lattice bed doesn't offer very good adhesion with PETG.

During longer prints (12hrs+) without partcooler (as I mostly use PETG) I noticed that one of the ducts had a slight deformation. Therefore although PETG seems to work OK (if you are using part cooling for your prints, I recommend filaments with higher glass transition tempertures like ABS, GreenTEC oder GreenTEC Pro.

Category: 3D Printer Parts

Tagi

thingiverseflsunqqsflsunqqflsunqqsflsunqqspro