1 / 15
Honeycomb magnetic front shelving cover 2 color XL — zdjęcie 1
1 / 15

Honeycomb magnetic front shelving cover 2 color XL

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Magnetic Honeycomb front cover for storage/shelf units.

Ocena
0 / 5
Polubienia
22
Pobrania
48
Wydruki
0
Wyświetlenia
903
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Noncommercial

Created this to make my office look a little tidier. I have made these magnetic so really simple to remove from my metal shelving. I currently use the shelves for my printers and general storage so need access when printing etc… takes quite a while to print these in 2 colours, but think it's worth the effort. 

Prints on the Prusa XL. Only 2 sizes at the moment 35cm x 89.5cm and 27cm x89.5cm (happy to make another size if needed just message me) - you can of course connect the sections.

MK3/MK4 2 color version - https://www.printables.com/model/657382-honeycomb-magnetic-front-shelving-cover-2-color-mm

Each front consists of 3 sections 

  • the 27cm version has left, center, and right (left and right are different)
  • the 35cm version has a center + sides (both sides are the same)

This takes up most of the XL bed, recommend printing the first 2 or 3 layers at 50-60% speed to reduce the chance of the print lifting and then increasing to 100% -  I found trying to print this at Input Shaping speeds was very hit-and-miss so start slow and then up the speed.

I used PLA Prusament orange and JAYO matte grey - better results setting the first layer temp to 210 rather than 215. 

Magnets 6mm x 6mm round - I only added 4 magnets at the top and 2 at each side of each section.. add as many as you need. the side magnets were pushing in flush to the print, the top ones were left a little raised due to the metal shelf design (spacer to help also uploaded). your shelves might be different from mine so do what makes sense. put the magnet on the side of some pliers and simply push it in - make sure you do this on a flat surface.

yes, this took forever to print but it looks pretty good :) and hides all the junk and printers when not in use.

Printed at 0.4mm layer height, 0.6 nozzle, 0.32 will just take a little longer.

You could repurpose this and use it for its original function (attaching it to a wall)

Tagi