1 / 1
No Chimney Mod for MK3S+ and MMU2S/MMU3 with 5mm Filament Indicator LED — zdjęcie 1

No Chimney Mod for MK3S+ and MMU2S/MMU3 with 5mm Filament Indicator LED

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The "No Chimney" mod for MK3S+ and MMU2S/3 with a filament indicator LED (without having to solder on the sensor board).

Ocena
0 / 5
Polubienia
22
Pobrania
77
Wydruki
0
Wyświetlenia
1002
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

I was gearing up for installing @Hedo3D's Filament Indicator mod when I learned about the No Chimney mod. While the MMU3 chimney has been working flawlessly, the chimney is a bit in the way when unscrewing the QSM-M5 fitting (which you have to do whenever filament gets stuck), and opening the idler door is a bit of a hassle. In short, the No Chimney mod looked great, and I wanted to try it out, but I also wanted that indicator LED, so I fired up Fusion 360 and added an LED structure (inspired by @Hedo3D's mod) to @schellek's fs-cover. Some prototypes later, this is the result.

I personally cut the threaded insert out of my "chimney-base" part (I could easily reprint that part if I needed it again) to reuse for this. For those who may not want to do that, I added a version with M5 threads instead of the hole for the insert. The version with threads was even used to print my final insert version, so it has been tested and confirmed working quite well (although the durability of the threads is most likely worse than using the insert).

For the LED indicator, I soldered a 5V LED  and a 56kOhm resistor to a 3-pin 2.54mm stacking/stackable header, that I connect as an extension between the sensor board and its connector (similarily to how @Hedo3D did it in their mod). If these extension pins are bent downwards (or upwards if you want to be extra safe and don't mind the look), the connector easily clears the frame. The voltages for the filament sensor in the support menu are exactly the same with and without my LED extension, so it shouldn't cause any issues on that front.

For assembling the No Chimney mod, refer to the excellent guide of the original model.

Tagi