MMU2 Light Bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a very simple LED light strip holder for the MMU2s
- Ocena
- 5 / 5
- Polubienia
- 18
- Pobrania
- 67
- Wydruki
- 1
- Wyświetlenia
- 1317
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The LED strip holder is designed to fit cleanly onto the bottom of the MMU2 Idler body as shown in the mock up sketch images.
This design is simple and easy to print in PETG with the supplied GCODE
- PLA will work fine as it's not a mechanical part but I wanted to keep it the same material as the MMU2 to make it less visible.
I designed it to neatly hold a 2 segment stretch of this LED FCOB strip light which is 24v.
https://www.aliexpress.com/item/4000145232270.html?spm=a2g0s.9042311.0.0.27424c4d2NrkR9
(4000K Natural White + 1m + 24v 360 leds)
These lights work perfectly as work lights at 4000K and 24v means they can be wired directly into the Einsy board without a converter.
The unit can be printed on it's own and super glued (Cyanoacrylate) in place.
Alternatively you could add it to the Idler body and print the whole thing as a single unit, though this would likely require supports
I have paired this with SethBon's Single LED Light Bar and routed the wires out of the back o the right side holder (a simple remix of this has been posted separately).