Poinsettia in a pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small Poinsettia in pot for Christmas decoration
- Ocena
- 5 / 5
- Polubienia
- 60
- Pobrania
- 199
- Wydruki
- 2
- Wyświetlenia
- 836
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter & Christmas & New Year's
- Licencja
- Creative Commons — Attribution — Share Alike
A small Christmas Poinsettia in a pot.
Printing instructions:
I have used the following:
1 pot.stl 0.2mm 15% infill, FormFutura Stonefil Terracotta
1 soil.stl 0.2 mm 5% infill, Prusament Galaxy Black PLA
1 stem_bottom.stl, 0.2mm 15% infill, Prusament Opal green PLA
1 stem_middle, 0.2 mm 15% infill, Prusament Opal green PLA
1 stem_top, 0.2 mm 15% infill, Prusament Opal green PLA
2 large_leaves.stl, 0.2 mm 15% infill, Prusament Opal green PLA
1 large_leaves.stl, 0.2 mm 15% infill, Prusament Lipstick Red PLA
1 small_leaves.stl, 0.2 mm 15% infill, Prusament Lipstick Red PLA
1 distance_block.stl, 0.2 mm 15% infill, Prusament Lipstick Red PLA
1 stamen.stl. 0.2mm 15% infill, Prusament Pineapple Yellow PLA
Use a hairdryer or heatgun(low heat, don't burn your fingers) to soften the leaves and fold them a bit, be careful not to heat the middle section as you then may have problems fitting the leaves to the stem afterwards.
Use a small drop of superglue to hold the red leaves ,stem and stamen together. It is not nessesary to glue the middle stem or the stem into to soil.
You can also leave out the middel stem for a lower version.