Nazgul 5 Battery Stop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hold the battery in place on the Nazgul 5 if you're not using a Gopro.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 257
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I'm a pretty bad FPV pilot. As shown by the fact my poor Nazgul 5 (V1) looks like a lawn mower. I've made this little stopper to help hold the battery in place during crashes because mine kept sliding forward enough to pull the connector out. I don't fly with a go-pro camera because there's just no point in watching the train wreck again. I just held the stop in with tie-wraps, and there's a little cut out so it can fit up against the battery pad.
I printed this in TPU but I guess PLA would work.
I used a support on the print bed for the cut-away on the bottom, but no supports for the tie-wrap hole. I don't think you'd ever get them cleaned out, and the bridge is so small that TPU jumps it no problem.