Nazgul 5 Battery Stop
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hold the battery in place on the Nazgul 5 if you're not using a Gopro.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 28
- Makes
- 0
- Views
- 257
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I'm a pretty bad FPV pilot. As shown by the fact my poor Nazgul 5 (V1) looks like a lawn mower. I've made this little stopper to help hold the battery in place during crashes because mine kept sliding forward enough to pull the connector out. I don't fly with a go-pro camera because there's just no point in watching the train wreck again. I just held the stop in with tie-wraps, and there's a little cut out so it can fit up against the battery pad.
I printed this in TPU but I guess PLA would work.
I used a support on the print bed for the cut-away on the bottom, but no supports for the tie-wrap hole. I don't think you'd ever get them cleaned out, and the bridge is so small that TPU jumps it no problem.