Makita DC18RD Battery Charger Wall Control mount - Version 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angled mounting points for the dual port Makita DC18RD Battery Charger to fit on the Wall Control modular pegboard.
- Ocena
- 4,5 / 5
- Polubienia
- 35
- Pobrania
- 179
- Wydruki
- 0
- Wyświetlenia
- 2395
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This uses the DDD Printable Wall Control System (github) creating an angled mount for the Makita DC18RD Battery Charger.
2024/6/22: Update - Version 2. Angle and mounting have been improved - it no longer requires a strap to keep it in place. Mount pins are now printed separately to avoid requiring support, thanks @CAS_334926 for the suggestion.
There are four mount points, Top Left and Right, Bottom Left and Right. I had initially tried to mount it at a low 5 degree angle against the board, but this proved unsatisfactory for balancing and holding the weight of the charger. Version 2 is now at 30 degrees which keeps it grounded well. Connect the pieces using the connector pins - I used 3 or 4 on each side of the bottom pieces, there's no need to fill them all. To tighten these in place, I found it helpful to use a clamp or two.
Print checklist:
- Bottom Left Center x 1
- Bottom Right Center x 1
- Bottom Left Sidepiece x 2
- Bottom Right Sidepiece x 2
- Top Left Center x 1
- Top Right Center x 1
- Top Left Sidepiece x 2
- Top Right Sidepiece x 2
- Mount Pin x 4
- Locking Spacer x 4
- Threaded pin x 4
- Connector Pin x 24 (or more)
