1 / 3
Makita DC18RD Battery Charger Wall Control mount - Version 2 — image 1
1 / 3

Makita DC18RD Battery Charger Wall Control mount - Version 2

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Angled mounting points for the dual port Makita DC18RD Battery Charger to fit on the Wall Control modular pegboard.

Rating
4.5 / 5
Likes
35
Downloads
179
Makes
0
Views
2,395
Reviews
2

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

This uses the DDD Printable Wall Control System (github) creating an angled mount for the Makita DC18RD Battery Charger.

2024/6/22: Update - Version 2. Angle and mounting have been improved - it no longer requires a strap to keep it in place. Mount pins are now printed separately to avoid requiring support, thanks @CAS_334926 for the suggestion.

There are four mount points, Top Left and Right, Bottom Left and Right. I had initially tried to mount it at a low 5 degree angle against the board, but this proved unsatisfactory for balancing and holding the weight of the charger. Version 2 is now at 30 degrees which keeps it grounded well. Connect the pieces using the connector pins - I used 3 or 4 on each side of the bottom pieces, there's no need to fill them all. To tighten these in place, I found it helpful to use a clamp or two.

Print checklist:

  • Bottom Left Center x 1
  • Bottom Right Center x 1
  • Bottom Left Sidepiece x 2
  • Bottom Right Sidepiece x 2
  • Top Left Center x 1
  • Top Right Center x 1
  • Top Left Sidepiece x 2
  • Top Right Sidepiece x 2
  • Mount Pin x 4
  • Locking Spacer x 4
  • Threaded pin x 4
  • Connector Pin x 24 (or more)

Tags