Hinged Retainer/Invisalign/Denture/Mouthguard Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple print in place hinged case for a retainer, mouthguard, denture or invisalign. Uses 6x2 magnets for the closure.
- Ocena
- 4,75 / 5
- Polubienia
- 73
- Pobrania
- 850
- Wydruki
- 9
- Wyświetlenia
- 2990
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
After trying some of the other options I'd seen online I wasn't particularly happy with the ergonomics of any of them and I definitely didn't like using bolts or dowels to make a simple hinge.
So I sat down and taught myself enough Fusion 360 to model this from scratch!
It prints nicely at 0.16-0.20 layer height from a .40 nozzle with no supports. All of the overhang angles are steeper than 45 degrees and the the hinge has at least .3mm of clearance so even with a relatively sloppy printer you should get some decently smooth motion.
The closure uses two “2mmx6mm” magnets stacked in each opening; make sure to orient the magnets in the correct direction, then put a drop of glue in the hole and push them in. They really pull the case shut with a satisfying SNAP! and keep it securely closed so your retainer doesn't end up in the bottom of your bag.
Per some feedback from my daughter I added some vent/drain holes in the bottom to keep the inside from getting funky :)
I'm really happy with how this thing turned out and it was a great learning experience.
This is Version 2 of my design, with smaller hinges that have steeper angles which should help people who had issues with the overhangs in the original.