Agazzani B18 Bandsaw Throat Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement throat plate insert for Agazzani B18 bandsaw
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 106
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A replacement throat plate for an Agazzani B18 bandsaw. Simplified and made with a minimal blade kerf to create a more-or-less zero-clearance insert.
I was contacted by a woodworker about printing them a replacement insert after they saw my posting for a throatplate for the Agazzani B20. Turns out, they had the smaller B18 model saw which uses a completely different throat plate design which didn't seem to be published anywhere. I had them send me the original part and modeled up this replacement.
This insert is just a friction/wedge fit in the opening in the casting with no provision for leveling, so I tried model this with the little fins a tiny bit oversized so it can easily be carefully sanded to fit perfectly.
Printing Parameters
- I would highly recommend printing in PETG for the added resilience as well as easy sanding for fitting if necessary.
- 0.2mm layer height
- I settled on 6 walls and 10 top and bottom layers to get the right balance between strength and springiness to keep the front of the open kerf open while wedging the insert into the table.