Waterpik Traveler Lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The Waterpik traverler was designed to use the reservoir inverted as a cover but it would be nice to have a lid.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 366
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
The Waterpik traverler was designed to use the reservoir inverted as a cover but it would be nice to have a set on cover once you are where you are going and set up. This is that cover. It sits inside and on top of the reservoir with two side grips for easily removal. Integrated in the side grips are covered vents to allow air to be drawn into the reservoir when the machine is in use.
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 5
Rafts:
No
Supports:
No
Resolution:
.25 mm layer height with 0.6 mm nozzle
Infill:
100%
Filament: filaments.ca PETG White
Notes:
Used a food contact plastic just to be safe. There shouldn't really be contact. A small section of the vent area is included for testing the fit and adjusting horizontal expansion on the printer parameters. It is intended to fit loosely but not knock off to easily.
Category: Bathroom