Shop vac to cyclone adaptors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed from the original because I took some of the dimensions from the freecad file, and I actually copied the…
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 1114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
I remixed from the original because I took some of the dimensions from the freecad file, and I actually copied the sketch that makes the thread.
Designed to fit this cyclone: https://au.banggood.com/Dust-Separation-Power-Dust-Collector-Cyclone-Separator-Vacuum-Cleaner-Filter-p-1543696.html
To go with this shopvac: https://www.productreview.com.au/listings/shopvac-super-20l-59703
I wanted adaptor that screws onto the hose, and fits inside the cyclone inlet and outlet than around them. This solution replaced duct tape and it worked quite well, but this is obviously a lot neater :-)
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
.28
Infill:
25%
Filament: Generic PLA White
Notes:
The attached freecad (version 0.19 project) project can generate both parts
See the spreadsheet in the project, currently its configured to generate the outlet part, you can change the values to the outlet to generate the slightly smaller inlet part.Category: Outdoor & Garden