Anycubic Filament Runout Sensor Redirection Mount for Kobra 2 Max / Kobra 2 Pro / Kobra 2 Plus/ Kobra 2 Neo / Kobra 2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows redirection of filament for easier travel to hotend when printing with a Top mounted spool holder.
- Ocena
- 4,889 / 5
- Polubienia
- 304
- Pobrania
- 2797
- Wydruki
- 20
- Wyświetlenia
- 11 631
- Oceny
- 18
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This allows redirection of filament for easier travel to hot end when printing with a top mounted spool holder.
Installation and Design explanation:
Runout Senor Bracket: Tighten down the bolt to sensor bracket to the bottom base. Then back your bolt off just enough, so your sensor bracket can move freely up and down.
Bottom Base: is designed if there is too much tension and friction with your filament going through the filament sensor it will slightly turn to show you there is a problem.
Other Option is Fixed mount allow no movement. No Safety Latch feature.
Updated Model 11/29/2023 v1.5
* Thickened Doesn't flex during repeated retractions. If printed with too low of infill.
Works great with this spool holder:
https://www.printables.com/model/658306-anycubic-kobra-2-max-top-side-mount-single-or-dual
Print with 25% infill
Hardware required M3 Bolts