2.54mm pitch "DuPont" Connector Protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A press-fit protective cover for cables having a male "DuPont" connector to protect the exposed pins. Various sizes.
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 66
- Wydruki
- 0
- Wyświetlenia
- 494
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model was built out of a need to extend a IDC connector on a main board outside of a case using a 2.54mm pitch “DuPont” connector. It has two main functions:
- Protect the exposed pins from accidental damage.
- Provide additional area to grip the connector that does not create strain on the wires.
There are 12 different pairs of models from 1x1 to 6x2. The protectors are press fit and you may need to slightly resize based on printer calibration. It is preferable to enlarge the top piece instead of shrinking the bottom piece or else the connector may not fit.
The 1x1 will work with standard jumper wires.
I have had no issues with connectors seating properly with this cable. The retaining ridge is 0.3mm.
A use case would be extending the SPI port on your printers board/Pi with a cable for easier access when connecting an accelerometer.