TPA3116D2 Amp Enclosure (V2)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
updated to V2 to add additional clearance for audio jacks which were deeper than I guessed. I took jbebels remix of…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 696
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
updated to V2 to add additional clearance for audio jacks which were deeper than I guessed.
I took jbebels remix of the Customizable Box and added the ability to have a second PCB. I also added in soe extra ventilation to the top panel. I also added a small 30x30x10 24v Fan attached directly to the amp heatsink in the final build to lower the temps a little bit.
The enclosure I want to make is for a TPA3116D2 amp board, but also have a DC-DC boost board in it so I can run the amp a closer to an optimal voltage off a standard DC laptop power supply.
This is designed to fit the following AMP: https://www.amazon.com/dp/B08JG95NXD
and DC Boost board: https://www.amazon.com/dp/B09878FGLR
Print Settings
Printer:
Two Trees Sapphire Pro
Rafts:
No
Supports:
No
Resolution:
200
Infill:
38
Filament:
eSUN PETG
Notes:
I manually changed the panel thickness when exporting the front and back panels to 2.5mm from the default 2 which makes them fit snugly. the default allows a little to much movement for my taste.
Category: Electronics